Can I just say I LOVE, love, love this idea?This is a large embroidery hoop that is covered in fabric, but wait - there is more! It is actually a corkboard! Ditch your boring rectangle board and add an artsy touch to your office decor!
Supplies:
Large embroidery hoop
Corkboard to fit snug inside back (draw on paper to make a template and then cut cork board)
Fabric
Aleene's® Fabric Fusion™ Permanent Dry Cleanable Fabric Adhesive™
Aleene's® Tacky® Transparent Tape for Crafters™
Foam brush
Clips
Directions:
1. Open the hoop (paint it if desired).
2. Use a foam brush to apply Fabric Fusion inside both hoops.
3. Insert the fabric and replace back hoop. Pull until it is taut and apply clips all around, let sit for 30 minutes.
4. Remove clips and trim excess fabric.
5. Set the hoop right side down on table.
6. Apply Tacky Tape generously around inner areas of taut fabric inside the hoop.
7. Set the corkboard inside so it fits snug up against edge of hoop.
8. Press in place.
Peace, love, and glitter!
Kathy :-)
P.S. Check out my new book and product line!
I love this idea! This is sooo kool! Thank you for the instructions. I have some of the rings that have been sitting here for years. Now I know what to do with them.
ReplyDeleteThis, my dear, is brilliant! Still nothing in the Covina store. Going to Pasadena tonight after work and will keep you posted!
ReplyDeleteSandi